Aokatec AK-4N Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Адаптер Aokatec AK-4N. Aokatec AK-4N 4 сторінки. Bluetooth gps adapter

How AK-4N work?

1. Turn the wireless GPS receiver on

2. Turn the camera off and connect AK-4N on camera¡s ten-pin remote terminal.

(Plug the remote switch to the AK-4N if need when camera is turned off.)

3. Turn the camera on. Camera will connect with GPS receiver automatically within 3

seconds. Do not need any setting. (The initial connection approx 30 seconds.)

After connection,

panel on top of the camera.

receiver did not detected enough satellites.

detected more than three satellites, GPS data will be recorded.

4. Take pictures, GPS data will be recorded with each photograph.

5. AK-4N keep working even when the camera off and sleep, it allow you to turn on and

take photo without waiting.

6. AK-4N will turn off, when camera and GPS receiver both turned off.

7. Turn the camera off and pick it up when not use.

Auto Meter Off

If Enable is selected for GPS > Auto meter off in the setup menu for D300, D300S, D700,

D3 cameras, the exposure meters will turn off automatically after the time specified in the

camera Custom Settings menu. This reduce the drain on the battery.

For D200, D2X, D2XS, and D2HS, these cameras lack a menu option to set Auto meter off,

the camera can¡t enter sleep mode when use GPS device. Auto meter draws much power

from the camera when keep long time working. When use AK-4N, it always provide GPS

data to camera, just turn the camera on or off depends on your shooting needs. Do not to

worry about the GPS acquisition.

icon will be displayed in the control

icon blink means GPS

AK-4N wireless adapter

icon keep on means GPS receiver