AOLYNK DR Series Посібник зі швидкого встановлення - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Мережевий маршрутизатор AOLYNK DR Series. AOLYNK DR Series 2 сторінки. Adsl2+ routers

Друкувати сторінку

automatically options, then click <OK>.

3.6 Logon

1) Check the configuration of the proxy server. Disable the proxy server

first when the PC is accessing the Internet through proxy server.

2) Use the Web browser. Enter http://192.168.1.1 in the address bar (by

default, the IP address of the DR series router is 192.168.1.1).

3) Log onto the Web setup manager. A new window appears prompting

you to enter user name and password. For the first logon, use the default

administrator user name admin with the password admin. The password

can be modified after entering the management interface.

admin

Figure 4 Entering the user name and password

Setup

After you log onto the Web page, follow the simple steps to finish the quick

configuration of the router:

1) Click the <Quick Setup> from the Navigation bar to the Quick Start

window. Select the PPPoE as the login type and input the VPI/VCI value

which is assigned by your ISP. You can consult your local ISP for the

VPI/VCI value. The user name and password are required for the PPPoE

<Apply>.

Input the local VPI/VCI

Input the username

and password

assigned by ISP

Figure 5 Setting parameters

2) Click <Status> from the Navigation bar to enter the Status tabbed page.

You can find that the WAN IP Address item presents an IP address of the

public network instead of the original 0.0.0.0.

Figure 6 Checking status

3) At last, click <Save Config> from the Navigation bar to enter the Save

configuration interface. To save the settings you have made, click <Save>.

Quick Troubleshooting

Table 2 Quick troubleshooting

Symptom

Solution

ADSL Link LED

The RJ-11 telephone cable must be used and connected to DSL

stays OFF.

and telephone ports correctly.

Access to the

Make sure that:

Internet fails.

1) You have followed all the steps described above and found no

problems.

2) The IP address of your PC is in the range of allocated valid

addresses. To check it, select the Run option from the Start menu.

In the pop-up window, input winipcfg (in Win98 operating system)

or ipconfig (in Win2000/XP operating system) for the IP address

checking.

3) You can ping the IP address of the gateway (192.168.1.1).

4) You have performed the correct DNS configuration on your PC.

5) You have disabled the proxy server.

Forget

Both of the default user name and password are admin. If you

password for web

have changed the password before but now forget it, press the

Reset button for five seconds to restore the default settings on the

router. Then you can access the Web page with the default user

name and password.

Note: The reset function restores the settings to the factory default

settings.

Access to the

Make sure that:

router Web page

1) The LAN LED is ON.

fails.

2) The settings of TCP/IP properties are correct.

3) You have entered the correct user name and password.

If you still cannot enter the router Web page, press the Reset

button for 5 seconds to restore the default settings.

The modification

You need to click <Apply> to save every modification. When you

on the Web page

finish all the settings, enter the Save Configuration page to save

fails to save.

them so that the settings will be valid the next time you power on

the router.