3Svision N8072 Короткий посібник - Сторінка 2

Переглянути онлайн або завантажити pdf Короткий посібник для Камера спостереження 3Svision N8072. 3Svision N8072 2 сторінки. Cube network camera

Друкувати сторінку

Connection diagram

Micro SD Card
MIC
●
●
PIR Sensor
●
Step1
Connect the product to the switch hub and PC.
1
Prepare the product, your PC and
switch hub ready for connection.
Prepare the product, your PC and switch hub
ready for connection.Make sure that your PC
has a LAN port available for connection to the
network cable of the product.
2
Connect the product to the power
source (as shown in the figure).
Connect the with your power adaptor directly.
The Power Led Indicator will light when the
power on.
Power
●
3
Connect the product to the switch
hub (as shown in the figure).
Use a network cable and plug it in the LAN port of the
product. Plug the other end of the cable in the LAN
port of the hub.
HUB
●
Illumination
HUB
Power
●
●
●
LED
Led Indicator
●
5 seconds
Speaker
Reset Button
●
●
4
Connect the switch hub to your PC
(as shown in the figure).
Prepare the product, your PC and switch hub
ready for connection.Make sure that your PC
has a LAN port available for connection to the
network cable of the product.
5
Turn on the power.
Turn on the power of the PC and hub.
After you have finished install the product.
* Please check if it is ready to use by the Led indicator
as below:
NET
It will light in green when the network is
connected.
STATUS It will light in yellow when any event triggered.
POWER
It will light in red when the power on.
Led Indicator
●
- Page 1 -
2
Step
Camera settings
Start
1
Execute the Cam Finder.exe file from the supplied CD.
Find the camera (Search)
2
Search for the product from your LAN. The default IP
setting 192.168.0.20 appears on the screen.
● Click Search to find the IP CAM on the LAN.
Changing the IP address and related
3
settings for the network environment
When you find the camera, click it and the settings
appear on the right side. You can change the settings
for the new network environment as you need.
Enter the settings for the new network
●
environment you need.
• You have to enter a new settings in the IP Netmask and
Gateway fields and keep the settings in other fields
PC
●
unchanged.
Submit data (Submit)
4
HUB
●
● Click Submit to apply the new settings.
Confirmation
5
● Click Exit to quit, after all chages have been confirmed.
Note:
If this software cannot run successfully, check that it is not
blocked by an anti-virus software or firewall.
3
Change the Internet Explorer
Step
settings
Start
1
Bring Up Your IE browser.
Check
2
Make sure that Level II, the commonly used default
security level, is set for the security.
Steps
Open the IE browser
↓
Tools
↓
Internet Options
↓
Security
↓
Custom Level
Select "medium" for security
3
Make sure that Level II, the commonly used default security
level, is set for the security.
Check that the security level is Level II.
●
Note: This product supports IE 6.0 or above.
OK
4
OK
Click
to quit.
Attention
1. Please refer to user manual for more detailed
explanation of the hardware installation.
2. Where no switch hub is available, you can
search and set up the camera using the
network peering approach.
However, you may need a jumper and need to
change the LAN configuration on your PC for
this purpose. It is recommended to request a
qualified engineer for the connection or execute
the network peering referring to the user's
manual .
- Page 2 -