Danfoss VLT Programmable I/O MCB 115 Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Приводи постійного струму Danfoss VLT Programmable I/O MCB 115. Danfoss VLT Programmable I/O MCB 115 16 сторінок.

Danfoss VLT Programmable I/O MCB 115 Посібник з монтажу
Installation Guide | VLT® Programmable I/O MCB 115
Extend the I/O selection available on the control card, for example, for multi-zone control with 3 pressure transmitters.
Turn the AC drive into a decentralized I/O block supporting building automation systems with inputs and outputs.
Support the extended PI controllers with I/Os for setpoint inputs, transmitter/sensor inputs, and outputs for actuators.
Provide a digital output used for:
-
Driving a relay.
-
Input to commonly used PLC I/O boards.
-
Input to another AC drive in a sequentially controlled application.
®
The VLT
Programmable I/O MCB 115 is intended for use only with:
VLT® HVAC Drive FC 102
VLT® Refrigeration Drive FC 103
®
VLT
AutomationDrive FC 301
®
VLT
AutomationDrive FC 302
®
The VLT
Programmable I/O MCB 115 is only functional if it is built into the drive. The option cannot be used as a standalone.

1.5.2 Foreseeable Misuse

Any use not expressly approved by Danfoss constitutes misuse. This also applies to failure to comply with the specified operating
conditions and applications.
Danfoss assumes no liability of any sort for damage attributable to improper use.

1.5.3 Items Supplied

®
When the VLT
Programmable I/O MCB 115 is not factory mounted, the following items are supplied:
®
VLT
Programmable I/O MCB 115 B-option with coated PCB, order number 130B1266.
LCP cradle
Front cover
Stickers for front cover
Installation Guide
Danfoss A/S © 2020.01
N O T I C E
Introduction
AN295938195323en-000101 / 130R0655| 5