Danfoss BasicPlus2 WT-T Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Терморегулятор Danfoss BasicPlus2 WT-T. Danfoss BasicPlus2 WT-T 8 сторінок.

Installation Guide

1. Installation Steps

1. Installation must be done by an authorised

electrician.

2. The room thermostat should be installed at approx.

1.5 m above floor and where the effects of sunlight,

draught or other heat sources (eg. TV's) are avoided,

see fig. 1.

3. First of all, carefully remove the cover and dial knob,

see fig. 2.

4. Connect the wire before mounting the back plate to

the wallbox using the enclosed screws. Then mount

the cover to the back plate, see fig. 3.

2. Wiring

See fig. 4 for dimensions and fig. 5 for wiring diagram.

WT-T is often used with a Danfoss TWA actuator.

Depending on the conditions of power location and

actuator type (NC or NO), the wiring between room

thermostat and actuator is different.

Follow the illustrations to complete the wiring.

1. When power supply location is close to room

thermostat:

• Connect to actuator TWA 230 V NC type, see fig. 6.

• Connect to actuator TWA 230 V NO type, see fig. 7.

2. When power supply location is close to actuator:

• Connect to actuator TWA 230 V NC type, see fig. 8.

• Connect to actuator TWA 230 V NO type, see fig. 9.

BasicPlus

WT-T Room Thermostat

VICUL202

Danfoss Heating Solutions