Danfoss DEVIreg 233 Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Терморегулятор Danfoss DEVIreg 233. Danfoss DEVIreg 233 12 сторінок.

DEVIreg™ 233

• Do not expose the thermostat to moisture, water,

dust, and excessive heat.

Mounting Instructions

Please observe the following placement guidelines:

• Place the floor sensor in a conduit in an appropriate

place where it is not exposed to sunlight or draft

from door openings.

• Equally distant and >2cm from two heating cables.

• The conduit should be flush with the floor surface -

countersink the conduit if necessary.

• Route the conduit to the connection box.

• The bending radius of the conduit must be min

50mm.

Installation Guide

Place the thermostat at a suitable height

on the wall.

In wet rooms, place the thermostat according to local

regulation on IP classes. Do not install the thermostat

in small bathrooms with poor ventilation, nor close

to the toilet due to the risk of condensed water and

water splash.

Note: A floor sensor enables a more accurate

temperature control and is recommended in all floor

heating applications and mandatory under wooden

floors to reduce the risk of over-heating the floor.