Installation Guide, DLG / ECL 110 / Danfoss Link™
Troubleshooting
Error indication
Impossible to add device, ECL, to the Danfoss Link™ CC system
The connection to the ECL is lost
Danfoss Link™ indicates communication error on the ECL and the DLG for
ECL has green light
Flashing LED on DLG
Low room temperature (below comfort settings)
Fejlfinding
Fejlmelding
Ikke muligt at tilføje enhed, ECL, til Danfoss Link™ CC systemet
Forbindelsen til ECL er mistet
Danfoss Link™ melder kommunikationsfejl på ECL og DLG for ECL lyser
grønt
Blinkende udgangs-/alarmlysdioder på DLG
Lav rumtemperatur (under komfortindstillinger)
EC - Declaration of conformity
Hereby Danfoss A/S declares that this equipment is in compliance with the essential requirements and other relevant provisions of
the Radio Equipment Directive.
VI.JM.C3.6K
Possible Causes
- The distance between the Danfoss Link™ CC and the DLG has
exceeded 1,5m.
- Check if the MODBUS address of the ECL controller is set to 5.
- Check your software version (house control/settings/about) of the Danfoss
Link™ CC and update if older than MkIII 3.2;
http://link.danfoss.com
For further information, see separate instructions for Danfoss Link™ CC and
Danfoss ECL Comfort 110 controller.
- The wireless signal is weak
- Defective device
For further information, see separate instruction
for the Danfoss Link™ CC.
- The cable connection between the ECL and the DLG is unstable / discon-
nected.
- Check if the cable connection between the ECL and the DLG has defects.
Fasten the screw terminals and if the error persists the cable has to be
changed.
- The CC is disconnected
- The wireless signal is weak
- Check if the ECL controller is left in setback due to lost connection.
- If connection is ok check the heat curve slope setting of the ECL controller
and increase if necessary.
Mulig årsag
- Afstanden mellem Danfoss Link™ CC og DLG overstiger 1,5 meter.
- Kontroller, om MODBUS adressen i ECL regulatoren er indstillet til 5.
- Kontroller, om din softwareversion (huskontrol/indstillinger/om) i
Danfoss Link™ CC og opdater, hvis den er ældre end MkIII 3.2;
http://link.danfoss.com
For yderligere oplysninger, se separate vejledninger til Danfoss Link™ CC
eller Danfoss ECL Comfort 110 regulator.
- Det trådløse signal er svagt
- Defekt enhed
For yderligere oplysninger, se separat vejledning
til Danfoss Link™ CC.
- Kabelforbindelsen imellem ECL og DLG er ustabil / afbrudt.
- Kontroller kabelforbindelsen imellem ECL og DLG for defekter. Efter-
spænd skrueterminaler, og vedbliver problemet, skift da kablet.
- CC er afbrudt
- Det trådløse signal er svagt
- Kontroller, om ECL regulatoren er efterladt i reduceret drift pga. tabt
forbindelse.
- Hvis forbindelsen er ok, kontroller den valgte varmekurve i ECL regula-
toren og hæv den hvis nødvendigt.
© Danfoss | 2017.03 | 7
Друкувати сторінку