Danfoss FP715Si Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Терморегулятор Danfoss FP715Si. Danfoss FP715Si 20 сторінок. Electronic 2-channel full programmer for heating and hot water with service interval timer
Також для Danfoss FP715Si: Інструкція користувача (2 сторінок)

Друкувати сторінку

•

The wallplate must be securely mounted either directly to the

wall using suitable wood screws or to a ﬂ ush mounted 1-gang

electrical accessory box using M3.5 screws.

•

Cable access can either be from behind for concealed cabling, or

from below for surface cabling. If surface cable is used, cut out

cable access slot on plug-on module prior to mounting.

•

For wiring connections refer to diagram below.

FP715 Si models are double insulated and do not require an

earth connection, however a parking terminal is provided on the

wallplate. This is clearly marked with an Earth symbol.

•

Prior to mounting the plug-on module, DIL switches on the rear

of the plug-on module must be set. See diagram on page 6 for

available options.

•

Mount plug-on module to wallplate by locating tabs on top of

wallplate in apertures on rear of module, hinge down and press

ﬁ rmly to wallplate before tightening securing screws on bottom

of wallplate.

3.1 Wiring

For wiring conversion tables please see pages 10-17).

Please Note:

On 24 volt models power

supply must be wired to

A & B on wallplate.

Please Note:

Always switch oﬀ mains ﬁ rst and never ﬁ t programmer to a live

wallplate.

Danfoss Heating

ELECTRONICS

N/C

N L 1 2 3 4

230V

Fused

N/O

N/C

N/O

OFF

DHW

HTG

DHW

HTG