Danfoss SET3M Посібник з монтажу - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з монтажу для Терморегулятор Danfoss SET3M. Danfoss SET3M 16 сторінок. Electro-mechanical
24 programmer for
heating & hot water
Також для Danfoss SET3M: Інструкція з встановлення та користування (20 сторінок)
Друкувати сторінку
1.0 Installation Guide
Please Note:
This product should only be installed by a qualifi ed electrician or
competent heating installer and should be in accordance with the
current edition of the IEEE wiring regulations.
2.0 System Overview
GB
Specifi cation
Power supply
Switch action
Switch rating
Setting accuracy
Timing accuracy
Enclosure rating
Max. ambient temperature
Dimensions, mm (W, H, D)
Design standard
Control Pollution Situation
Rated Impulse Voltage
Ball Pressure Test
3.0 Installation
1. Fix the wallplate to the wall or fl ush mounted box as required.
The connections are at the top and the vertical centre line of
the unit, at the position shown on the diagram C/L (in line with
terminal ).
2. Surface cables can only enter from below the unit. If mounted on
a fl ush mounted box, cables can enter from the rear through the
aperture in the wallplate.
3. For mains voltage applications a link must be fi tted between
terminals L, 2 and 5.
4. Whilst the unit does not require an Earth connection, a terminal is
provided on the wallplate for Earth continuity purposes.
4
230 ± 15% Vac, 50/60Hz
2 x SPDT Type 1B
Max 264 Vac, 50/60Hz, 3(1) A
± 5 minutes
± 1 min/month
IP30
45°C
158 x 98 x 58
EN 60730-2-7
Degree 2
2.5kV
75°C
SET3M