3T-Components 3T-MOTORS 3T45-40B Посібник з монтажу та експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Внутрішнє оздоблення приміщень 3T-Components 3T-MOTORS 3T45-40B. 3T-Components 3T-MOTORS 3T45-40B 20 сторінок. Shutter / awning motors
Друкувати сторінку
INSTALLATION INSTRUCTIONS
On the opposite side of the motor, push the roller capsule out of the roller shutter shaft until it fits into the ball bearing inserted in the wall bearing.
•
Fix roller capsule to roller shutter shaft with self-tapping screw. Position the screw at a punched hole. This prevents the screw from slipping.
•
Roller capsule
Shutter motor wiring:
7
Connect the roller shutter motor and switch (or timer) to the mains.
•
The electrical connection of the roller shutter motor and control unit may only be carried out by qualified personnel.
•
If the drive should run in the opposite direction after installation, the motor's upstream and downstream leads (brown + black) must be turned.
•
Power grid
230 V / 50 Hz
1) brown / black = L1 / Phase
2) blue = N Neutral conductor
3) green/yellow = PE Protective conductor
Adjustment cable ESK
The connection diagram of time switches differs from this
circuit diagram! Please refer to the corresponding manual
for the connection diagram.
1 (L1)
2 (N)
3 (PE)
The white wire is unoccupied and
must be insulated. To do this, push
the enclosed wire end cap onto the
wire end and press it together with
crimping pliers or combination pliers.
Wall bearing +
Ball bearing
1
2 (Up/Down)
3 (Up/Down)
4 (N)
5 (PE)
1) white = Programming cable, not assigned
2) black = Departure or ascent
3) brown = Departure or ascent
Wire end cap
4) blue = N Neutral conductor
5) green/yellow = PE Protective conductor
1
2 (Up/Down)
3 (Up/Down)
4 (N)
5 (PE)
If the end points are set using the ESK setting cable, do not
connect the switch or timer until after the end points have
been set (page 11)!
3T-MOTORS Tubular motors | Installation instructions
Shutter motor
230 V / 50 Hz
Shutter motor
230 V / 50 Hz
10