Aetina Nvidia Jetson Series Посібник користувача - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник користувача для Несучі дошки Aetina Nvidia Jetson Series. Aetina Nvidia Jetson Series 14 сторінок.
Також для Aetina Nvidia Jetson Series: Посібник із швидкого старту (7 сторінок), Посібник користувача (13 сторінок)

Друкувати сторінку

6. Software & BSP.

When customer use Nvidia standard BSP, some I/O function may not work. In order to

support Aetina ACE-N510 system I/O config, please follow below method.

(1) Before Installing the BSP you will need to install Jetpack on the x86 host system(UBUNTU14.04)

Download the proper JetPack from

https://developer.nvidia.com/embedded/downloads

(2) Download R28_1_TX2_N510_1.tar.gz from website.

https://www.aetina.com/support-download.php?t=4&p1=86

(3) After the JetPack is installed, copy the patch file TX2_N510_1.tar.gz to the target folder

TX2: Copy R28_1_TX2_N510_1.tar.gz to /64_TX2/Linux_for_Tegra_tx2/

(4) Use the following command to patch the config and flash BSP:

TX2:

tar xvf R28_1_TX2_N510_1.tar.gz

./setup.sh tx2 N510

Recovery system

The TX1/TX2 embedded system contains a recovery system and could be triggered by GPIO.

(1) For TX1, shut down the system first and connect the 3V3 pin & GPIO_4 (GPIO 184)

For TX2, shut down the system first and connect the 3V3 pin & GPIO_4 (GPIO 481)

(2) Boot the device,

It will need about 4 minutes for recovering the system.

After finishing, it will shut down the device.

Remove the connected pins and power on the device.

(for N510)

- 10 -