Danfoss 176F4047 Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з монтажу для Конвертер мультимедіа Danfoss 176F4047. Danfoss 176F4047 14 сторінок. In-bottom/out-top cooling kit for fa11-fa12, frequency converters
In-bottom/Out-top Cooling Kit for FA11-FA12
Installation Guide
6.
Collapse the duct until installation of the cabinet top plate.
1
2
3
4
5
6
Illustration 8: Installation of the Top Duct Over the Top Vent
1
Threaded stud
2
Top duct
3
M5x14 screw
4
M5x12 screw
2.7 Installing the Duct Support Bracket
The duct support bracket attaches the bottom duct to the lower end of the cooling back channel. To install the bracket, use the
following steps. Refer to
Illustration
Procedure
1.
Remove the paper backing from the duct support gasket.
2.
Adhere the gasket to the upper surface of the duct support bracket.
3.
Position the bracket at the lower end of the cooling back channel.
4.
Secure the bracket to the back channel of the frequency converter using 8 M5x14 screws (T25) from the kit.
Torque fasteners to 2.3 Nm (20 in-lb).
Danfoss A/S © 2022.12
9.
5
Top of frequency converter
6
Cooling back channel
7
Upper flange of duct
8
Lower flange of duct
AN361429548582en-000201 / 136R0255 | 9
Installation
7
8