Danfoss iC7 Series Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Конвертер мультимедіа Danfoss iC7 Series. Danfoss iC7 Series 8 сторінок. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Також для Danfoss iC7 Series: Посібник з монтажу (8 сторінок), Посібник з монтажу (8 сторінок), Посібник з монтажу (6 сторінок), Посібник з монтажу (14 сторінок), Посібник з монтажу (16 сторінок), Посібник з монтажу (8 сторінок), Посібник з монтажу (10 сторінок), Посібник з монтажу (16 сторінок), Посібник з монтажу (16 сторінок), Посібник з монтажу (6 сторінок), Посібник з монтажу (6 сторінок), Посібник з монтажу (16 сторінок), Посібник з монтажу (18 сторінок)

Pedestal Kit for FK09/FB09 and FK10/FB10

Installation Guide

2 Installation

QUALIFIED PERSONNEL

Only qualified personnel are allowed to install the parts described in these installation instructions.

Disassembly and reassembly of the frequency converter must be done in accordance with the corresponding service guide.

Use the standard fastener torque values from the service guide, unless the torque value is specified in these instructions.

ELECTRICAL SHOCK HAZARD

The frequency converter contains dangerous voltages when connected to mains voltage. Improper installation, and installing or

servicing with power connected, can cause death, serious injury, or equipment failure.

Only use qualified electricians for the installation.

Disconnect the frequency converter from all power sources before installation or service.

Treat the frequency converter as live whenever the mains voltage is connected.

Follow the guidelines in these instructions and local electrical safety codes.

DISCHARGE TIME (20 MINUTES)

The frequency converter contains DC-link capacitors, which can remain charged even when the frequency converter is not pow-

ered. High voltage can be present even when the warning indicator lights are off.

Failure to wait 20 minutes after power has been removed before performing service or repair work can result in death or serious

injury.

Stop the motor.

Disconnect AC mains, permanent magnet type motors, and remote DC-link supplies, including battery back-ups, UPS, and

DC-link connections to other frequency converters.

Wait 20 minutes for the capacitors to discharge fully before performing any service or repair work.

Measure the voltage level to verify full discharge.

ELECTROSTATIC DISCHARGE

Electrostatic discharge can damage components.

Ensure discharge before touching internal frequency converter components, for example by touching a grounded, conduc-

tive surface or by wearing a grounded armband.

N O T I C E

W A R N I N G

N O T I C E

Installation

AN371942906358en-000101 / 136R0256