Dunster House H4-1818ASH Посібник з монтажу - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з монтажу для Садові будиночки Dunster House H4-1818ASH. Dunster House H4-1818ASH 15 сторінок. Adam i shed - 1.8m x 1.8m (6ft x 6ft)

Друкувати сторінку
STEP 2: FLOOR
Items:
7x
ST-PT35351750 (Bearer)
1x
MFP - 1750x1220x10
1x
MFP - 1750x480x10
42x 35mm SCREW (6/Bearer)
6x
50mm SCREW
Bearer layout (1.0)
ST-PT35351750
360
360
STEP 3: PANELS
Items:
1x
PANEL CB - 1750x2134 (REAR PANEL)
1x
PANEL DB - 1750x2134 (FRONT PANEL)
1x
PANEL AI - 1700x1897 (SIDE PANEL NO WINDOW)
1x
PANEL BG - 1700x1893 (SIDE PANEL WITH WINDOW)
16x 50mm SCREW
20x 70mm SCREW
6x
90mm Screws
Principle of panels installation 1.0
FRONT PANEL
90mm SCREW
70mm SCREW
Assembly Steps
Pre-drill parts before fixing with screws
2a) Ensure the base is level. Space bearers at the
specified distance as shown in the the diagram below
(1.0). If the bearer layout consists of double bearers, use
50mm screws to secure them as shown in the image to
the right (1.1).
2b) Secure the MFP to the bearers with 35mm screws all
equally spaced. There should be a 70mm space between
the ends of the bearer and the screw.
MFP - 1750x1220x10
185 190
360
1700
Pre-drill parts before fixing with screws
50mm Screw
Principle of floor board(s) installation
Use 35mm screws. Keep equal distance between
screws. Use same amount of screws per each
bearer.
FRONT
MFP - 1750x480x10
ST-PT35351875
SIDE PANEL
70mm SCREW
Joining double bearer (1.1)
Use 50mm screws.
50mm SCREW
Approx. 70mm
3a) Position front panel as shown in the
diagram below. Use 3x 90mm screws per
each side (not in the doorway) to secure
the front panel to the bearer. Use 3x
70mm screws to secure the panel to the
bearers (in the doorway).
3b) Use 4x 50mm screws equally spaced
screws to secure ST-PT35351875 to the
front panel. Refer to image on the left.
3c) Position side panel as shown and use
1x 70mm per each bearer to secure it to
the floor.
3d) Use 4x 50mm screws spaced
approximately 500mm apart to secure the
side panel to the front panel.
3e) Repeat these steps for all remaining
panels except the rear panel. Use 6x
50mm screws all equally spaced for the
rear panel
Double
Bearer
35mm SCREW
Page 8