Duo-Therm 59516.331 Посібник з монтажу та експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Кондиціонер Duo-Therm 59516.331. Duo-Therm 59516.331 17 сторінок. Roof top air conditioner/heat pump
Також для Duo-Therm 59516.331: Інструкція з монтажу Посібник з монтажу (17 сторінок)
Друкувати сторінку
A. LOCATION
The proper location of the thermostat is very important to ensure that is will provide a comfortable RV temperature. Observe
the following general rules when selecting a location.
1.
Locate the thermostat 54" above the floor.
2.
Install thermostat on a partition, NEVER on an outside wall.
3.
NEVER expose it to direct heat from lamps, sun or other heat producing items.
4.
Avoid locations close to doors that lead outside, windows or adjoining outside walls or directly under cabinets or overhangs
which limit air movement.
5.
Avoid locations close to supply registers and the air from them.
6.
NEVER locate thermostat in a room that is warmer or cooler than the rest of the coach - such as the kitchen.
7.
The major living area is normally a good location.
B. CABLE INSTALLATION
1.
A four-conductor cable, 18 to 22 AWG is to be used for low voltage connections.
2.
Choose the shortest, direct route from the 14-1/4" x 14-1/4" (±1/8") opening to the thermostat location selected.
3.
Consider where screws, nails or staples might contact the cable.
4.
Leave approximately 6" of cable extending through the wall for connection to the thermostat.
5.
Leave approximately 15" of cable extending into the 14-1/4" x 14-1/4" (±1/8") opening for connection at unit.
6.
If system is to control a gas furnace: Route a 18 gauge wires from the furnace to wall thermostat.
7. PLACING THE AIR CONDITIONER ON THE ROOF
A. Remove the air conditioner from the carton and discard carton. The unit mounting bolts and literature are in separate plastic
bag. Be sure to place this information in the RV.
B. Place the air conditioner on the roof.
FIG. 5
Please Recycle
All Cardboard
C. Lift and place the unit over the prepared opening using the gasket on unit as a guide. The roof gasket on the bottom of the
base pan goes toward the front of the RV. Sliding the unit on the roof will damage the roof gasket. See FIG. 6.
FIG. 6
D. Place 3104998 Relay Kit and Return Air Cover Kit, inside the RV. These cartons contain mounting hardware for the air
conditioner and will be used inside the RV. This completes the outside work. Minor adjustments can be done from the inside
of the RV if required.
6. THERMOSTAT & CABLE INSTALLATION
Front
INSTALLATION INSTRUCTIONS DUCTED BI-METAL
!
This unit weighs approximately 100 pounds.
To prevent back injury, use a mechanical
hoist to place air Conditioner/heat pump on
roof.
CAUTION
Do not slide the unit. This may damage the
neoprene gasket attached to the bottom and
create a leaky installation.
9
CAUTION