Casio V.P.A.M fx-115 Посібник - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник для Калькулятор Casio V.P.A.M fx-115. Casio V.P.A.M fx-115 16 сторінок.
¢ [4] - CMPLX
Mode
Specify this mode to perform complex number calcu
lations. The ''CMPLX"'
indicator is shown on the dis
play when
the unit is in the CMPLX
Mode.
2. Specifying the BASE-N Mode
1 Press the
key five times and Mode Specifica
tion Menu
No. 5 appears
as shown
below.
BASEN
(2) Hen the number
key to specify the BASE-N
ode.
« (1) - BASE-N Mode
Enter this mode to
perform conversion between binar,
octal, decimal and Hexadecimal! number systems, or tc
perform logical operator calculations. The ''BASE-N'
indicator is shown on the display when the unit is ir
the BASE-N
Mode.
"The COMP, SD, LR, CMPLX
and BASE-N modes are
all independent of each other. You cannot use ther
in any combination. Whenever power is switched of
by the Auto Power Off function, restoring power au-
tomatically enters the last mode you were in wher
power
switched off.
M@ Specifying an Angle Unit Mode
(1) Press the
key two times and Mode Specifica-
tion Menu
No. 2 appears
as shown
below.
-
Press the number key that corresponds
to the unit
of angular measurement
mode you want to specify.
The following describes the meaning of each mode.
« {1] - DEG Mode
Use this mode to specify degrees as the unr of angu-
lar measurement. The '''DEG" indicator 6 shawn on the
display when the unit is in the DEG
Mode.
* f2} - RAD Mode
Use this mode to specify radians as the unit of angutar
measurement.
The ''RAD"" indicator is shown on the
display when the unit is in the RAD
Mode
¢ £3} — GRA Mode
Use this mode to specify grads as the unit of argular
measurement.
The ''GRA" indicator is shown on the
display when the-unit is in the GRA Mode.
*The DEG, RAD, and GRA modes can be used in any
calculation
mode
except
the
BASE-N
Mode.
Whenever power is switched off by the Auto Power
Off function, restonng power automatically enters the
last mode you were in when power switched off.
M@Specifying a Display Mode
'1, Press the bea] key three times and Mode Specihca-
tion Menu
No. 3 appears as shown
betow.
FIX
sci
MOR
2, Press the number key that corresponds to the dis-
play mode
you want to specify.
The following describes the meaning of each mode.
e (1) - FIX Mode
Use this mode to specify the number of decimal places
to the right of the decimal point. The 'FIX' indicator
is shown on the display when the unit is in the FIX
Mode.
When you enter this mode, the message '0 ~ 97°" ap-
pears on the display. Press a number key from [0] to
to specify the number of decimal places.
~
1O-