AETOOL GLOW PLUG ANALYSER Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Вимірювальні прилади AETOOL GLOW PLUG ANALYSER. AETOOL GLOW PLUG ANALYSER 6 сторінок.

Calibration Procedures:

1. Use the tester black clamp to clip to its red test probe tip as shown above.

2. Switch ON the tester by pressing

immediately press and hold

calibration process has completed.]

2. Moments later the tester will then display

from 5 to 0.

3. Then it switches to saving mode

and completes the whole calibration.

4. Release the

beep continuously. The reading should be 0.00 as shown if not repeat the

calibration procedures again.

5.0 OPERATION:

1. Disconnect the positive power supply to the glow plug terminal.

2. Attach the tester black clip to the vehicle chassis ground (Note: Ensure it is a good

ground contact).

3. Power up the tester by pressing the

4. Its screen will light up and display as follows:

button. [Note: Do not let go until the whole

button, the display will go to

button. When the display show

with numbers countdown

and seconds later to

button once.

and the alarm will