AudioControl ACX-3.2 Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Стерео еквалайзер AudioControl ACX-3.2. AudioControl ACX-3.2 20 сторінок. All-weather equalizer & crossover with paging mic
Друкувати сторінкуGuided Tour of the ACX-3.2 (continued)
17. Crossover Bypass – By default, the crossover state is set
to off. When in the off state, full range signal is passed
from the main input to the front and rear outputs. When
in the on state, the front and rear outputs will receive a
high passed signal at the set crossover frequency. The
sub output will receive a low passed signal at the set
crossover frequency whether the crossover is on or off.
18. Crossover Frequency – The frequency setting of this pot
determines the frequency that the front and rear outputs
of your ACX-3.2 will play down to, as well as determining
where your subwoofer will begin playing. The Crossover
1&
Bypass Switch (
) lets you defeat the crossover, so if
your system does not use a separate subwoofer, all your
amplifiers will get a full range signal.
19. Input Level – This pot is used to increase the amount of
signal voltage to your power amplifiers. With this control
you can provide up to 9.5 Volts (peak) to your amplifier's
inputs. Check with your amplifier manufacturer's specs
to determine exactly how much voltage they can
really handle. More info on this in the section on "Level
Matching" page 12.
20. Gain Maximized LED – This LED indicates when gain
has been maximized for optimum performance. With
your source unit turned up to 75% (or maximum output
below distortion), use the Input Level controls to dial in
the input gain, watching for this LED to shine, then back
it off just a touch.
2)
1&
1*
1(
7