Aetrex GPS Shoes Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для GPS Aetrex GPS Shoes. Aetrex GPS Shoes 20 сторінок.

Друкувати сторінку

Avoid Direct Contact with Body RF Exposure:

Do not wear the Aetrex GPS Shoes if the shoes are damaged or any

part of the GPS unit or antenna comes in contact with the skin. The

Aetrex GPS Shoes were designed so that they create a safe distance

between the body and the GPS device. To maintain compliance

requirements, always use an insole with your shoes. Should the shoes

become damaged, or if any interior becomes exposed, avoid wearing

them.

Other Safety Precautions:

Interference:

As with all wireless devices, your Aetrex GPS Shoes may experience

electrical interference which may affect their performance.

Exposure to Water & Inclement Weather:

Your Aetrex GPS Shoes are not water resistant or waterproof. While

they are designed as ordinary shoes, it is recommended the shoes

be used where it is relatively dry and not subjected to water, snow, or

submersion or severe elements which could affect performance of the

GPS tracking.

Qualified Service:

The Aetrex GPS Shoes do not contain any user serviceable or

replaceable parts (except for shoelaces). Non-working shoes must

be returned for repair or replacement to Aetrex Worldwide, Inc. with

prior authorization as set forth in the Warranty procedures. Do not

disassemble the shoes or their accessories. If service or repair is

required, contact the manufacturer. If the shoes are disassembled,

the risk of shock, fire, personal injury or damage may result and any

warranty will be voided.

Accessories:

Use only manufacturer approved accessories for your GPS Shoes. Do

not connect any other devices. Doing so will void the warranty.

Specific Absorption Rate (SAR) Information:

The Aetrex GPS Shoes meet certain government requirements for

exposure to radio waves. The shoes contain a radio transmitter and

receiver similar to a cellular phone. It is designed and manufactured not

to exceed the emissions limits from exposure to radio frequency (RF)

energy set by the Federal Communications Commission of the U.S.

government when used in accordance with the instructions set forth

in this manual. These limits are part of comprehensive guidelines and

establish permitted levels of RF energy for the general population. The

guidelines are based on standards that were developed by independent

scientific organization through periodic and thorough evaluation of

scientific studies. The standards include a substantial safety margin

designed to assure the safety of all persons, regardless of age and

health. The exposure standard for wireless devices employs a unit of

measurement known as the Specific Absorption Rate, or SAR. The SAR

limit set by the FCC is 1.6W/kg.1 Tests of SAR are conducted using

standard operation positions specified by the FCC with the GPS device

transmitting at its highest certified power level in all tested frequency

bands. Although the SAR is determined at the highest certified power

level, the actual SAR level of the GPS device while operating can be

well below the maximum value. This is because the GPS device is

designed to operate at multiple power levels so as to use only the

power required to reach the network. In general, the closer the device

is to a wireless base station antenna, the lower the power output.

Before a GPS device is available for sale to the public, it must be tested

and certified to the FCC that it does not exceed the limit established by

the government-adopted requirement for safe exposure when used in

accordance with manufacturer instructions. The tests are performed in

positions and locations (e.g. near or on the body) as required by

the FCC for each model. The SAR value for the locator is less than

1.6 W/kg measured at a minimum separation.

FCC Compliance & Warning to Users:

This device complies with Part 15 of FCC Rules, and may generate

or use radio frequency energy. Operating this device is subject to

the following conditions: (i). This device may not cause harmful

interference; and (ii). This device must accept any interference

received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for

a Class B digital device pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates uses

and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference

to radio communications. however, there is no guarantee that

interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures: