Freedom Innovations PLIE 3 Довідник з програмування - Сторінка 2
Переглянути онлайн або завантажити pdf Довідник з програмування для Медичне обладнання Freedom Innovations PLIE 3. Freedom Innovations PLIE 3 2 сторінки.
Друкувати сторінку
Set Toe
Threshold (TT)
and Swing
Transition (ST)
In the Setup Wizard window on the right,
and ST.
Ask patient to walk approximately 5-10 steps
normal pace, 5-10 steps slow, and 5-10 steps fast. As
steps are collected, the progress bar will turn from
red, to yellow, to green and the program will calculate
new TT and ST values based on the steps collected.
Click Manual
to lock in the TT and ST values
•
If program is not registering steps, ensure patient
is able to take at least 5 prosthetic steps in a
straight line and/or gradually lower TT for a more
consistent knee release.
Confirm Settings
Verify the settings are appropriate by asking
patient to walk slow, normal and fast pace. The
knee should release freely at all speeds. If
capable, ask patient to walk in a slow, small
figure 8 pattern and walk backwards. The knee
should release and swing freely during fiigure 8
but not release when walking backwards. Refer
to Table 3 for troubleshooting if needed.
©2020 Freedom Innovations, LLC. All rights reserved. Plié 3 is a trademark of Freedom Innovations, LLC.
4
Manual
Adjustments
Follow the instructions on the screen
click TT
to manually adjust the knee based on
the recommended starting points found
in Table 2.
Table 2: Manual Adjustments
Setting
Manual Adjustments
a)
b)
c)
Troubleshooting
Table 3: FAQ Troubleshooting Tips
If You See This
Knee does not
release into
swing
Knee releases
into swing
Knee releases
into swing but
then quickly
locks up
Toe is scuffing
floor
Knee is not
keeping up
Knee "bobble"
or knee
instability
moment
5
Recommended Value
Low K3
Swing Extension Assist
20-25 psi
Stance Flexion
2-3.5
Swing Extension
0-1
When
Walking normal
pace or slow
Figure of 8
Walking
backwards
Walking small,
slow figure of 8
pattern
Normal walking
Normal walking
Walking or
Standing
Plie 3 Programming Reference Guide
a
Mod K3
High K3
25-40 psi
35-55 psi
1.5-3
1.5-2.5
0-2
0-2
What to Adjust
How
Toe Threshold
Decrease
(TT)
by 50 pts at
a time
Flexion Angle
Decrease
Timer & PreSwing
by 50 pts at
Timer
a time
Flexion Angle
Increase
Timer & PreSwing
gradually
Swing Flexion
Decrease
(air)
Swing Flexion
Increase
(air)
Alignment
Confirm flexion
contracture is
accommodated,
Shift socket
further anterior
over the
knee
IFU-03-010 Rev.B
b
c