3Ware 9690SA Series Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Комп'ютерне обладнання 3Ware 9690SA Series. 3Ware 9690SA Series 11 сторінок. Remote battery board
Також для 3Ware 9690SA Series: Посібник з монтажу (4 сторінок)

Друкувати сторінку

Updating the Firmware

Uninstalling 3ware Software Under

OpenSolaris

www.3ware.com

Firmware updates to the 3ware RAID controller can be done from CLI or by

using the bootable CD image.

For details on updating the firmware using the CLI, see the discussion of the

command /cx update in the 3ware SAS/SATA RAID Controller CLI

Guide.

For details on using the bootable CD image, see "Updating the Firmware

Through DOS Using the 3ware Bootable CD," in Chapter 10 of the 3ware

SAS/SATA RAID Software User Guide.

Electronic versions of these documents are available at

http://www.3ware.com/support/userdocs.asp.

Note:

After updating the firmware, a complete system shutdown and reboot is

required.

The following steps describe how to uninstall software on OpenSolaris from

the command line. If you do not use the -console option, the installer will

assume you want GUI mode. You must be root to run the uninstaller.

To uninstall software under OpenSolaris

Navigate to the directory where you installed the software. The default

directory is /opt/AMCC.

Change to the subdirectory "_uninst".

To uninstall in text mode, type:

./uninstall.bin -console

To uninstall in graphical mode, type:

and press

./uninstall.bin

Follow the prompts to remove the installed components.

Updating the Firmware

and press

Enter

Enter.