ASSIGNABLE JACK
SUS(sustain): Specifies a sustain*
1
pressed.
SoS (sostenuto): Specifies a sostenuto*
pressed.
SFt (soft): Specifies reduction of the sound's volume when the ped-
al is depressed.
rHy (rhythm): Specifies START/STOP button operation when the
pedal is depressed.
1.
Press the TRANSPOSE/TUNE/MIDI button until the
ASSIGNABLE JACK screen appears.
Example: When sustain is currently set
J
c a
k
2.
Use the [+] and [–] or [0], [1], [2], and [3] buttons to
change the setting.
Example: To select rhythm
J
c a
*1 Sustain
With piano tones and other sounds that decay, the pedal acts as a
damper pedal, with sounds being sustained longer when the pedal
is depressed. With organ tones and other continuous sounds, notes
played on the keyboard continue to sound until the pedal is released.
In either case, the sustain effect is also applied to any notes that are
played while the pedal is depressed.
*2 Sostenuto
This effect performs the same way as sustain, except that it is applied
only to notes that are sounding already when the pedal is depressed.
It does not affect notes that are played after the pedal is depressed.
When SUS is set
Pedal depressed
When SoS is set
Pedal depressed
E-38
TRANSPOSE/TUNE/MIDI
TOUCH
ACCOMP
KEY LIGHT
RESPONSE
VOLUME
TOUCH
RESPONSE
KEY LIGHT
METRONOME BEAT
TEMPO
MODE
VOLUME
SYNCHRO/
INTRO
ENDING
POWER
MAX
FULL RANGE
CHORD
FINGERED
START/
STOP
CASIO CHORD
NORMAL
MIN
NORMAL/
VARIATION/
SONG BANK CONTROLLER
FILL-IN
FILL-IN
START/STOP
effect when the pedal is de-
2
effect when the pedal is de-
O u
O
t
k
O u
O
t
Pedal released
Pedal released
= Keyboard depressed.
= Sustained notes
TRANSPOSE/
GM
TUNE/MIDI
MEMORY
STEP
MEMORY
STEP
SPLIT
LAYER
(TIE)
7
8
9
4
5
6
DEMO
3-STEP LESSON
1
2
3
REST
0
STEP 1
STEP 2
STEP 3
[+]/[–]
Number buttons
SOUND RANGE SHIFT (Default: On)
on: Shifts low range tones one octave lower and 072 PICCOLO one
octave higher.
oFF:Plays low range tones and 072 PICCOLO at their normal levels.
1.
Press the TRANSPOSE/TUNE/MIDI button until the
SOUND RANGE SHIFT screen appears.
S
i h
2.
Use the [+] and [–] or [0] and [1] buttons to change
the setting.
Example: To turn SOUND RANGE SHIFT off
S
i h
Messages
There is a wide variety of messages defined under the MIDI stan-
dard, and this section details the particular messages that can be sent
and received by this keyboard. An asterisk is used to mark messages
that affect the entire keyboard. Messages without an asterisk are those
that affect only a particular channel.
NOTE ON/OFF
This message sends data when a key is pressed (NOTE ON) or re-
leased (NOTE OFF).
A NOTE ON/OFF message include a note number (to indicate note
whose key is being pressed or released) and velocity (keyboard pres-
sure as a value from 1 to 127). NOTE ON velocity is always used to
determine the relative volume of the note. This keyboard does not
receive NOTE OFF velocity data.
Whenever you press or release a key on this keyboard, the correspond-
ing NOTE ON or NOTE OFF message is sent from the MIDI OUT
terminal.
Press the key
MIDI OUT Terminal
Release the key
MIDI OUT Terminal
f
t
O
u
t
f
t
O
u
t
NOTE ON
• Note number (tone)
• Velocity (volume)
NOTE OFF
• Note number (tone)
• Velocity (volume)
474A-E-040A
Друкувати сторінку