AUDIOFOCUS EVO12a Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Стереосистема AUDIOFOCUS EVO12a. AUDIOFOCUS EVO12a 16 сторінок.

1. Active version (EVO8a, EVO10a, EVO12a, EVO15a, EVOSub15a, EVOSub18a)

These models receive two ways

includes 4 presets for most of the applications we can meet on pro audio field.

Here's a description of the rear panel of Subs and Tops units:

Diagnosis and status Leds

Limit: ON when output signal is @-3dBspl of the peak.

Temp: ON when working temperature is too high. The electronics get in protection

(attenuation of signal, and stop if temperature still increases). In case of working in hard

temperature conditions (front of the sun), we invite the user to use our cover to protect the

amplifier against any over-heating problem.

Signal: ON when a signal is detected at the input of the cabinet.

Ready: ON after a few seconds, the system is ready for use.

digital high efficiency amplifiers. These ''green'' energy amplifiers

1. Volume control from -∞ to +6dBu.

2. Diagnosis and status Leds.

3. Balanced output XLR connector (male, 2+, 3-, 1GND).

4. Preset selection switch.

5. IN main power supply connector (powercon)

6. OUT main power supply connectors (powercon)

7. Balanced input XLR connector (female, 2+, 3-, 1GND).

This connector is parallel wired with the input (3) to link some cabinets together.

8. Preset status leds.

1. The main voltage must be ALWAYS earthed to protect user in case of

current losses or bad insulation.

2. ALWAYS replace the fuse with the same type and value (T3.15A/240V).

3. Make sure that the power switch is set to "OFF" before you connect the devices

4. A good cable improves the sound quality. Input cables should be as short as

possible.

5. If long signal cables are necessary, you should use balanced cables.