Daniamant Dan W3-1 Інструкція з монтажу та обслуговування - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з монтажу та обслуговування для Освітлювальне обладнання Daniamant Dan W3-1. Daniamant Dan W3-1 12 сторінок. Lifejacket light
Друкувати сторінкуMaintenance
Routine service
Dan W3-2 is maintenance free, but the following checks must be made annually:
1. Inspect the light for signs of damage or corrosion.
2. Press the on/off button *for one second and the light will commence
flashing, then press the button once more* and the light should
deactivate.
3. To test the Sensor Switch and the cable – a paper clip may be applied to
the 2 water contacts. It is recommended that the light is activated for 1
minute.
Replacement
The Dan W3-2 lifejacket lights have a storage life of 5 years and must be
replaced by the date shown on the label.
Health and safety information
Dan W3-2 lights contain Lithium cells. These must be handled correctly:
Do not dismantle the light assembly
Do not make any external electrical connection
Do not recharge
Do not incinerate
Store between -30°C and +65°C
The Batteries are hermetically sealed pressurised primary Lithium/Manganese
cells, and as supplied are electrically protected by a solid state device, and are
environmentally protected by a moulded plastic housing. In this condition the units
pose no definable hazard to health.