Audiolab ICE-2400 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Audiolab ICE-2400. Audiolab ICE-2400 9 сторінок.

Rear panel

1. Channel 1 XLR Input This XLR input is a

balanced input. Connect this input to the left

output of your mixer.

2. Channel 1 Link Socket This balanced socket

is used to link another amplifier.

3. Channel 2 XLR Input This XLR input is a

balanced input. Connect this input to the left

output of your mixer.

4. Channel 2 Link Socket This balanced socket

is used to link another amplifier.

5. Operation Mode Selector This switch is used

to choose the operating mode of the power

amplifier: Mode stereo: 2 inputs(channel 1 and

2) and 2 outputs are used. Mode parallel: 1

input(channel 1) and 2 outputs are used. Mode

bridge: 1 input(channel 1) and 1 output are

used.

6. Input Sensitivity Selector This selector

allows to choose the input sensitivity: either

0.75V, 1.0V, 1.5V).

7. ON/OFF Switch

switch ON, the amplifier adds low- frequen-

cy compensation so as to enhance speaker

output. The results (the actual change in the

low-frequency balance) will vary according to

the speaker type.

8. Channel 1 Turn Lock Output Connect this

turn lock output to a speaker. The branching is

+1,-1(except in bridge mode where the branch-

ing is +1,+2 ).

9. Channel 2 Turn Lock Output Connect this

turn lock output to a speaker. The balance is

+1,-1.

10. Wiring Terminal According each output

11. AC Cord Plug this cord into the power supply

12. Air Entrance Speakon connector This part

If you set this

mode , connect with split plug or bare wire

to Out 1,Out 2 , BRIDGE .

socket. (Before using the power amplifier,

check if the power supply is 220V).

is the air entrance. Don't obstruct it.

P. 5

AUDIOLAB ICE SERIES