AEV ACUO 908 Series Короткий посібник - Сторінка 11

Переглянути онлайн або завантажити pdf Короткий посібник для Музичний мікшер AEV ACUO 908 Series. AEV ACUO 908 Series 17 сторінок. On air broadcast console

Друкувати сторінку
AEV ACUO 908 Series Короткий посібник
Room & Studio section
1
2
3
4
5
Control Studio selection
1 – Button for selecting the EXT input for
routing it to the Control Studio output.
2 - Button for selecting the master PGM output
for routing it to the Control Studio output.
3 - Button for selecting the master UTL output
for routing it to the Control Studio output.
4 - Button for selecting the master AUX output
for routing it to the Control Studio output.
5 - Button for selecting the CUE bus for routing
it to the Control Studio output.
Control Room selection
6 – Button for selecting the EXT input for
routing it to the Control Room outputs.
7 - Button for selecting the master PGM output
for routing it to the Control Room outputs.
8 - Button for selecting the master UTL output
for routing it to the Control Room outputs.
9 - Button for selecting the master AUX output
for routing it to the Control Room outputs.
Master setup
Master knob jog ; directly it select the Gain headphone level, the range is -∞ ÷ +8 dB;
in sequence, the following commands:
1th push-buttom Control Room level (-∞ ÷ +8 dB)
2th push-buttom Control Studio level (-∞ ÷ +8 dB)
3th push-buttom PGM output level (-12 ÷ +12 dB)
4th push-buttom External input level (-12 ÷ +12 dB)
5th push-buttom CUE interlock (OFF/ON)
6th push-buttom PGM Digital sample rate ( 32, 44.1, 48, 96 KHz )
7th push-buttom UTL Digital sample rate ( 32, 44.1, 48, 96 KHz )
8th channel selection to associate the command I / O Start/Stop A (GPIO 1)
9th channel selection to associate the command I / O Start/Stop B (GPIO 2)
10th channel selection to associate the command Out Start/Stop C
AEV Broadcast Srl, via della Tecnica 33 – 40050 Argelato (BO) Italy
ACUO 908 Serie - AEV ON AIR CONSOLE
6
7
8
9
10
Web site www.aev.eu
11
Talk Back
10 - Button to active the Talkback function to the
Control Studio outputs.
Talk back Regia to Studio:
When the TB (talk back) button is pressed, the
signal of the enabled microphone is sent to the
Control Studio output.
•
Channel with function talkback to studio
(TBST: ON)
•
Channel in STOP
What happens:
•
the Talk back button of the remote fader
up
•
the previous selection of the Control Studio flashes
•
the audio signal present in the Control studio is
replaced by the channel selected in TB
Talk back Studio to Regia :
(need the Remote Fader)
•
Channel
connected to the Remote Fader unit
talkback function activated (STCR: ON)
•
Channel in STOP
What happens when the remote TB (talk back)
button is pressed:
•
the Talk back button of ACUO
•
the previous selection of the Control Room flashes
•
the audio signal present in the Control Room is
replaced by the channel connected to the Remote
Fader unit
•
the signal of the enabled microphone is sent
to the Control Room output.
lights
with
flashes