Daniela DAN9DD Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Вентиляційна витяжка Daniela DAN9DD. Daniela DAN9DD 20 сторінок. 90cm down draft rangehood

Друкувати сторінку
INSTALLATION OF THE DUCTWORK (DUCTED HOODS ONLY)
CAUTION
To reduce the risk of fire, use metal ductwork is preferred.
•
Decide where the ductwork will run between the hood and the outside.
•
A straight, short duct run will allow the hood to perform most efficiently.
•
Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few
of them as possible. Larger ducting may be required for best performance with longer duct
runs.
•
The air must not be discharge into a flue that is used for exhausting fumes from appliances
burning gas or other fuels" "Regulations concerning the discharge of air have to be fulfilled.
•
Install wall cap. Connect round metal ductwork to cap and work back towards hood
location. Use duct tape to seal the joints between ductwork sections.
INSTALLATION OF ELECTRICAL
•
The electrical wiring must be done by a qualified technician in accordance with all
applicable codes and standards. This range hood must be properly grounded. Turn off
electrical power at service entrance before wiring.
•
If the supply cord is damaged, it must be replaced by the manufacturer or a Daniela
Appliances Pty Ltd service agent, to avoid a hazard.
•
Do not use the plug and an extension cord other than the ones initially supplied
with the hood.

INSTALLATION OF THE HOOD

1.
On stainless steel hoods, carefully remove the plastic protective film from all exterior
surfaces of the hood and chimney prior to final installation.
2.
At least two people will be required to mount the hood.
P
I
02 9604 1226
E
I
INSTALLATION & USE
W
|
danielaappliances.com.au
PA G E 7