Audiomedia AMV108F Посібник - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник для Автомобільна відеосистема Audiomedia AMV108F. Audiomedia AMV108F 16 сторінок. In car av system

8. INSTALLATION AND CONNECTIONS

5. Pull out the original dome light Power wire and Signal/power Cable through the

original dome light opening.

6. Place the rubber on the player 14

7. Connect input and output cables.

8. Connect the wire harness in the following order: ground wire, battery wire,

ACC wire and door wire.

9. Attach the DVD player to the metal mounting plate using the CM 4x10 screws.

10.Reconnect the terminal of the battery.

Notes:

Do remember to connect the red wire to the ACC of the ignition switch. Or the battery

charge might be drained off prematurely.

If the fuse is opened, first make sure that the cables have not caused a short circuit,

and then replace the old fuse with a new one of the same ratings.

Do not have unconnected cables or terminals touch the metal on the car or any other

conducting material.

To prevent short circuits, do not remove the caps from unused terminals or from the

ends of the unconnected cables.

After the display unit is installed, check and make sure the brake lights, blinkers,

wiper, etc. on the vehicle are working properly.

Insulate unconnected wires with vinyl tape or other similar material.

English