Caslon speedcote Посібник з експлуатації та технічного обслуговування - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з експлуатації та технічного обслуговування для Ламінатор Caslon speedcote. Caslon speedcote 11 сторінок. Wax coater

Друкувати сторінку
Start Up
Connect the machine to an approved outlet and switch the machine on by using the red
'Power' button mounted on the rear of the machine.
Warm up time is normally 45 minutes. When the machine has reached the correct operating
temperature the 'ready' light on the front of the machine will illuminate. The motor can now
be switched on allowing the coating roller to turn. When switching on the motor, always
allow the roller to turn for 20 seconds to help it reach the correct operating temperature.
Applying wax
The Speedcote wax is very strong, so for most lightweight stocks or photographic papers
you only need a very thin coating. For textured or thicker stocks, such as canvas, you would
need a heavier coating.
1. Turn on the motor switch located at the front of the machine. Feed the print in with one
hand and catch it as it comes out with the other hand. Do not let the print drop down as it
exits. Turn off the motor after coating the print.
for more than five minutes at a time or it will overheat and cut out. The motor will only start
to operate again when it has cooled down.
2. For longer prints, such as posters, take the leading edge as it exits and guide the print
back towards the front of the Speedcote. The small upper roller is also driven and will assist
with guiding the poster back towards the operator.
Page 5
During warm up, the coating roller gets heated
up by the wax. It is very important that the level of the wax
be above the "full" block (top block, located in the left side
of the tray). If the wax is too low, the warm up will take
longer and the roller will have trouble turning.
: the motor should not be left running