Belcat ELAN-4TN Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Belcat ELAN-4TN. Belcat ELAN-4TN 2 сторінки. 4band eq with fnd tuner

Друкувати сторінку

INSTALLATION MANUAL

1. Contents

2. Battery

VOL.

L.B

1. Preamp

4. Output Jack

2. Tool

1. Electric Drill

2. Drill Bit

(2.3mm or 3mm)

3. Phillips Screwdriver

5. Insert EQ and battery box into hole of guitar.

6. Fasten screws properly.

7.Installing the pick-up

Pick-up

wire

3. Pick-Up

Box

5. Clip

6. Screw

4. Router and Grinder

(cutting-edge 3mm)

5. Round File

6. Masking Tape

5. Put plugs

into jacks.

1. Cut out the hole with template

Cutting

Masking

Template

ape

Preamp

3.Drilling hole for Jack

Masking

ape

12mm

Out put Jack

8. Fix wire with clip

Clip

Battery box

Cable

Solution

1) When there is no sound or sound is stopped,

- Check guitar cable, amp or Mixer

- Check if there is batter or not. When it happens noise or distortion,

please exchange battery.

- Check if the pickup and battery connector is connected correctly

or not.

- Check if out put jack is connected correctly.

2) When there is hum-noise,

- Check the pickup is connected well or not.

- Check if the connectors are connected to correct position well

or not.

3) Some causes of the balance problem

- When the bottom of saddle or the groove of saddle is not flat.

- When saddle is installed to the groove of saddle loosly.

- When the connection is not good between the bottom of saddle

and the groove of saddle.

- When Saddle is very short

- When there is grounds on the groove of saddle.

- When Saddle is declined toward front or back.

- When the top of guitar is bended.

- When the pickup is installed to only a part of the groove of saddle.

(back page)

2. Cut out the hole with Battery Box

Cutting

Template

Masking

ape

Battery Box

4.Drilling hole for pick-up

Out put jack

Cable

Pick-up

Wire