Audiophonics HPA-S600NC Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Audiophonics HPA-S600NC. Audiophonics HPA-S600NC 10 сторінок.

Audiophonics HPA-S600NC Посібник користувача

Operation of the device

Power the device
First, connect the power supply connector (2) of the amplifier to a main power outlet using the supplied power cable. Press the ON/OFF button (1) on the unit. The
LED on the button will light up. The amplifier is now turned on.
Note: Before plugging in and supplying power to the unit from a main power outlet, be sure to check that the power supply voltage selector on the bottom of the ampli-
fier is set to match the voltage supplied by your household electrical system. Incorrect power supply voltage settings can result in equipment and physical damages.

Input selection

Each channel allows you to select an input independently thanks to two switches (one per channel). Move the switches up to select the XLR input. Move the switches
down to select the RCA input.
Trigger usage
This amplifier has a built-in trigger input (3) and trigger output (7) operating in the 5-12VDC range. These can be connected to the trigger inputs and outputs of other
devices to set up a chain that automatically turns on your audio system when a signal is received and turns it off when no signal is detected.
Settings
The Audiophonics HPA-S600NC amplifier has a 4 level gain control and allows to activate or not its buffer as well as its front panel LED. These settings can be made
with jumpers and DIP switches positioned under the device.
Gain setting
The HPA-S600NC provides a gain level adjustment. Four different gain levels are available. The settings are made by means of a DIP switch. The following diagram
details the different possible configurations:

Buffer setting

The amplifier includes a buffer, which is activated by default. However, if necessary, it can be deactivated by placing the jumper in the Bypass position. The possible
configurations are as follows:
Power LED ON/OFF setting
The ON/OFF button of the amplifier is surrounded by a status LED, which is lit by default when the device is turned on. This can be disabled by means of a jumper
on the bottom of the unit. The configurations are as follows:
7
EN