audiophony Combo 240 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач audiophony Combo 240. audiophony Combo 240 13 сторінок.
Друкувати сторінкуENGLISH
[11] Loudspeakers output terminal
Connect your speakers here as follows:
- When using 100V speakers, connect the com
to the COM connector and the positive to the
connector corresponding to the chosen zone.
When using a multi-zone system, connect all the
coms to the COM connector. The total power
of the speakers must not exceed the maximum
power of the amplifier.
- When using 16 to 4 Ohms speakers (or a set of
speakers), plug the GND connector and the + to
the 4 Ohms connector. In this case, the total power
of the speakers must be identical to the amplifier
power (+/- 10%) and the total impedance must be
within 4 Ohms.
5 - Cable diameter depending on the installation:
You will find below an indicative table of the cable diameter to use depending on the power and distance:
Amplifier power: 100V 0.75mm² 1.0mm² 1.5mm²
30W
60W
120W
240W
The speakers should always be wired in parallel and the sum of the speakers power must never exceed the
nominal power, failing which severe damages to the amplifiers may occur.
The SPEAKER OUTPUT delivers a dangerous voltage of 100 V
Please turn your system off when changing cables.
800m
1000m
400m
500m
200m
250m
100m
130m
COMBO240 - Multi-zone mixer/amplifier
WARNING: Dangerous output voltage
Please use electric cables compliant
WARNING :
2.5mm²
1600m
2600m
800m
1300m
400m
600m
200m
300m
(100V )
with the current safety regulations.
4.0mm²
4200m
2100m
1000m
500m