Audiophony PA H9988 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Бездротовий телефон Audiophony PA H9988. Audiophony PA H9988 16 сторінок.
Друкувати сторінку
English
3 - Installation
3.1 - Connecting the receiver
AUDIO OUTPUT
UNBALANCED
BALANCED
AUDIO OUTPUT
UNBALANCED
LINE MIC
BALANCED
BALANCED OR
UNBALANCED CABLE
MIXING DESK
AMPLIFIER
AUDIO OUTPUT
UNBALANCED
BALANCED
Page 6
GO series microphones - Lavalier, headband or handheld UHF systems
DC INPUT
12V 500mA
CHANNEL
SQ
LINE MIC
5
1
9
13
DC INPUT
12V 500mA
CHANNEL
SQ
5
9
1
13
AC ADAPTER
LINE
DC INPUT
12V 500mA
CHANNEL
SQ
LINE MIC
5
9
1
13
- Connect the supplied AC adapter to
an electrical outlet, and to the DC
12V socket located at the rear of the
GOMono receiver.
- Connect the audio output to your
mixing desk with either a balanced
XLR cable or unbalanced Jack 6.35.
- Do not use both the unbalanced and
balanced outputs simultaneously
as it might cause signal losses and
increases parasitic noises.
- In order to preserve a good sound
quality and prevent distortions, you
can adjust the volume by following the
instructions below:
- If you are using a microphone input of
your mixing desk or amplifier, turn the
volume to half power (approximately),
the balanced and unbalanced outputs
level will then be close to 77 mV.
- If you are using a line level input of
your mixing desk or amplifier, turn the
volume to 3/4 of the maximum power,
the unbalanced and balanced outputs
SPEAKER
will then be close to 770 mV.
MIC
- Adjust the output level to the input
level used by the mixing desk.
- MIC level: - 20dBm
- LINE level: 0 dB