Addonics Technologies RT54S2HMEU Посібник

Переглянути онлайн або завантажити pdf Посібник для Зберігання Addonics Technologies RT54S2HMEU. Addonics Technologies RT54S2HMEU 2 сторінки.

Друкувати сторінку
I.
Installing drive into the RAID Tower V
key lock to the Lock position. This will secure the drive and turn on the
power to the hard drive.
Two HPMs are mounted on the tower. One HPM is connected to the
disk array for 2.5" SATA drives. The other HPM is connected to the 4
Snap-in Mobile rack for 3.5" SATA drives.
Note: It is recommended to fill up the RAID Tower V with SATA drives
from left to right and top to bottom. This is to help in identifying which
drives connect to which ports for easier troubleshooting.
II.
Connecting the power cable and RAID Tower V to the
computer
a.
Connect the power cord provided from the wall outlet to the back of
the RAID Tower.
b.
Make sure the power is off (power LED light should be off).
c.
Connect either the provided USB or eSATA cable from the back of
the RAID Tower to the computer. We recommend connecting the
eSATA port for best performance if this port is available on your
computer.
II.
Photo identifying SATA ports on HPM
SATA
Port 4
SATA
Port 1
SATA
Port 2
USB 5-Pin Header
Pin 1
ADDONICS TECHNOLOGIES
Step 1
Mount 2.5" SATA hard disk drivs into the
drive tray and slide the tray into the drive
bay.
Step 2
Using 3.5" SATA hard disk drive, slide the
drive into the drive bay. Close the front
panel and using the key provided, turn the
PM Health LED
eSATA LED
USB LED
Pin 1
LED pins
SATA
Port 3
Rotary Switch
LED Pin Assignment
Model: RT54S2HMEU
III.
Power on/off control
Turn on the power to the RAID Tower Mini by pressing the power
button on the front. The power LED light should lit indicating the power
is on.
IV. Setting RAID on the HPM
1.
Attach the SATA hard drives (up to 4) to the SATA ports on the
Hardware Port Multiplier (HPM) using SATA cables. It is
recommended to connect drives to the SATA ports 1 to 4
successively.
2.
Set the Rotary switch to the RAID mode required.
3.
Push the RAID setting button with a ballpoint pen tip while the HPM
is turned off.
Use a ballpoint pen
tip to press the
RAID Setting Button
Power LED
Power Switch
HPM 1 (Top disk array)
(LED 1) HPM Health
(LED 2) eSATA Status
(LED 3) USB Status
HPM 2 (Snap-in racks)
(LED 1) HPM Health
(LED 2) eSATA Status
(LED 3) USB Status
RAID
setting
button
RAID config
rotary switch
eSATA port
Power Switch
Power Connector
USB port