Consort PLSTi100RX Посібник зі встановлення та керування - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник зі встановлення та керування для Обігрівач Consort PLSTi100RX. Consort PLSTi100RX 4 сторінки. Wireless controlled plsti low surface temperature fan heaters with intelligent fan control
Також для Consort PLSTi100RX: Посібник зі встановлення та керування (4 сторінок)

Друкувати сторінку

Controls

When the appliance is connected to the mains

supply and the wall socket is switched 'ON' the

mains neon indicator will light, showing that the

power is available to the unit.

Operation

This heater can only be used when connected

to a CRX2 wireless programmable controller.

Each CRX2 can control any number of heaters.

Please refer to the CRX2 installation and con-

trol guide for full operational details.

USTOMER

ELPLINE

Should you need any advice on the use of your new Consort product please contact our Helpline:

Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT

Tel: 01646 692172 Fax: 01646 695195 Email: [email protected] Web: www.consortepl.com

Operation hours: Mon to Thu 8.30am to 4.30pm | Fri 8.30am to 3.30pm

66000797 Iss 02

Intelligent Fan Control

The intelligent fan control incorporates one of the

latest low energy consumption EC motors. This allows

the heater to operate quietly, whilst still providing the

best possible levels of comfort.

The intelligent fan control is only activated when the

heat is switched on. If the heater is running in fan/

boost mode only (heat switched off), then the fan

will operate at a fixed speed.

When activated, the intelligent fan control detects

the temperature of the room. Depending on which

heat mode is activated, it will calculate the best

possible airflow temperature and will adjust the fan

speed accordingly.

NOTE: When turning the heater on, or changing heat

mode or fan speed mode, the fan will

accordingly after a small time delay.

Mounting

This unit is for wall mounting only. It is designed to be very

quiet in operation if mounted correctly. It must be fitted using

the wall bracket supplied which has been specially designed

to minimise noise levels. Care must be taken when handling

the bracket not to bend or distort it.

CRX2

wireless

controller

When fitting more than one heater into a room we would

recommend that they are sited on the same wall to optimise

airflow and ensure quiet operation.

OUNTING ON A

•

NB: Failure to follow the instructions and recommendations

provided could result in increased noise levels.

Consort Equipment Products Limited

BS EN ISO 9001 Registered Company No FM12671

LASTERBOARD

ALL

Ensure at least one of the wall brackets is secured

to the timber frame of the studded wall by using

standard wood screws.

Where the bracket is fitted onto plasterboard only,

ensure plasterboard fixings are used. Standard wall

plugs will not be suitable.

Where possible mount the heater(s) on an outside

wall to inhibit transfer of sound within the building.

respond