Consort PLSTi150SL Посібник зі встановлення та керування - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник зі встановлення та керування для Обігрівач Consort PLSTi150SL. Consort PLSTi150SL 4 сторінки. Sl wireless controlled low surface temperature fan heaters with intellingent fan control
Друкувати сторінку
4
Controls
When the appliance is connected to the mains
supply and the wall socket is switched 'ON' the
mains LED indicator will light, showing that the power
is available to the unit.
Operation
This heater can only be used when connected
to any SL wireless controller. Each SL controller
can control any number of heaters providing
they are in the RF range.
SLPB
SLVT
SL wireless controllers
Please refer to the SL installation and control
guide for full operational details.
C
H
USTOMER
ELPLINE
Should you need any advice on the use of your new Consort product please contact our Helpline:
Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT
Tel: 01646 692172 Fax: 01646 695195 Email: [email protected] Web: www.consortepl.com
Operation hours: Mon to Thu 8.30am to 4.30pm | Fri 8.30am to 3.30pm
66000959 Iss 01
SLTI
SLVTB
Consort Equipment Products Limited
BS EN ISO 9001 Registered Company No FM12671
Intelligent Fan Control
The intelligent fan control incorporates one of the latest
low energy consumption EC motors. This allows the heater
to operate quietly, whilst still providing the best possible
levels of comfort.
The intelligent fan control is only activated when the heat
is switched on. If the heater is running in fan/boost mode
only (heat switched off), then the fan will operate at a
fixed speed.
When activated, the intelligent fan control detects the
temperature of the room. Depending on which heat
mode is activated, it will calculate the best possible airflow
temperature and will adjust the fan speed accordingly.
NOTE: When turning the heater on, or changing heat mode
or fan speed mode, the fan will respond accordingly after
a small time delay.
Mounting
This unit is for wall mounting only. It is designed to be very
quiet in operation if mounted correctly. It must be fitted
using the wall bracket supplied which has been specially
designed to minimise noise levels. Care must be taken
when handling the bracket not to bend or distort it.
When fitting more than one heater into a room we would
recommend that they are sited on the same wall to
optimise airflow and ensure quiet operation.
M
P
OUNTING ON A
LASTERBOARD
•
Ensure at least one of the wall brackets is secured
to the timber frame of the studded wall by using
standard wood screws.
•
Where the bracket is fitted onto plasterboard only,
ensure plasterboard fixings are used. Standard wall
plugs will not be suitable.
•
Where possible mount the heater(s) on an outside
wall to inhibit transfer of sound within the building.
NB: Failure to follow the instructions and recommendations
provided could result in increased noise levels.
W
ALL