Consort EV2650 Посібник - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник для Джерело живлення Consort EV2650. Consort EV2650 16 сторінок.
Друкувати сторінкуManual programming
Manual programming permits to set voltage, current, power and time limits for a simple routine
electrophoresis run. Parameters can be changed temporarily without interrupting the run.
1. Verify if the instrument is switched off.
2. Connect the electrophoresis tank to the instrument.
3. Switch the instrument on.
4. Select MANUAL and press :
PROCEDURE?
MANUAL
METHOD
SETUP
6. Enter the desired current limit and press :
MANUAL
CURRENT
500
8. Enter the desired timer unit (h or kVh)
and press :
MANUAL
TIMER UNIT
10. Press / to start the experiment. See
At any time, you can return to the main menu by holding pressed.
•
At any time, you can avoid programming unnecessary parameters. To do so, simply press / instead of
•
after entering the last relevant value and the instrument will immediately start the experiment keeping the
other parameters to their previous values.
To ensure that the desired parameter is kept constant, we suggest to pre-set all other parameters to its
•
maximum.
A blinking unit of the controlling parameter appears when the regulation is complete.
•
The timer will always count down except when no timer value has been entered.
•
Rev. 1605
mA
h
5. Enter the desired voltage limit and press :
7. Enter the desired power limit and press :
9. Enter the desired timer value
and press :
The value format is 'hh:mm' when entering a
value in hours. The format is a value with 2
decimals when entering kiloVolthours. Set to
zero when required to continue until / is
pressed or the power is switched off.
Running
Condition.
Manual Power Supplies
MANUAL
VOLTAGE
300
V
MANUAL
POWER
150
w
MANUAL
TIMER
00:30
h
8