Constellation audio Inspiration PREAMP 1.0 Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Constellation audio Inspiration PREAMP 1.0. Constellation audio Inspiration PREAMP 1.0 16 сторінок.
Також для Constellation audio Inspiration PREAMP 1.0: Посібник користувача (16 сторінок)
Друкувати сторінкуInput setup screen
When you press the multifunction button labeled
Setup on the input screen, this screen will
appear. It allows you to set up a home theater
bypass input; set minimum and maximum output
levels, and change the phase of the output
signal.
To flip the phase of the PREAMP 1.0's output
signal: Use the multifunction button below the
display.
To set minimum and/or maximum levels: Adjust
the PREAMP 1.0's volume to the desired
minimum or maximum level, and press either the
Set Min or Set Max button, depending on which
function you want, and hit Apply to accept the
setting. To clear the setting, press either CLR
Min or CLR Max as appropriate, or press Default
to clear both settings.
To set up a home theater bypass input: First
select the input you want to use for this
function, then adjust the volume on the PREAMP
1.0 to the desired level. Push the Set Min button,
then the Set Max button, then the Apply button.
To clear these settings, press CLR Min then CLR
Max, or press Default.
Screen setup screen
To adjust LCD brightness: Press the + and –
buttons on the left side of the screen, on either
side of the dark dot.
To adjust LCD contrast: Press the + and – buttons
on the right side of the screen, on either side of
the half-dark/half-light dot.
To adjust LCD backlight timeout: Press the
Timeout button in the lower left corner to keep
the screen lit for 15 sec., 30 sec., 1 min., 5 min.,
10 min., and always on.
To accept or cancel screen setting changes: Press
the Apply or Cancel button, respectively.
To return to the factory default settings: Press
the Default button. This will bring up a screen
asking "Are you sure you want to set this device
to its default settings?" Hit the Yes button to go
to default settings, the No button to cancel.
12