Constellation audio Inspiration PREAMP 1.0 Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Constellation audio Inspiration PREAMP 1.0. Constellation audio Inspiration PREAMP 1.0 16 сторінок.
Також для Constellation audio Inspiration PREAMP 1.0: Посібник користувача (16 сторінок)
Друкувати сторінку10. Return/back
This button brings you back to the previous control screen. For example, from any input's screen, such
as XLR 1, it will take you back to the input selector screen.
11. Standby/power
Push this button to turn the PREAMP 1.0 on and off. When you turn the unit on, it will take a few
seconds to warm up. When the preamp is ready for use, its LCD screen will show the most recently
selected input. To put the unit in Standby mode—which will silence the audio but keep the power
supply on so the unit stays warmed up—press this button again after turning on the power.
Hold this button down for 5 seconds to turn the preamp off. The unit will enter cool-down mode for 10
seconds. During cool-down, no buttons on the unit or remote will operate.
12. Multifunction button
The multifunction button serves different functions depending on which control screen is shown. A
label on the LCD display will show the function of the button.
13. Mute
Press this to button to silence the PREAMP 1.0 temporarily. The numerical volume readout will flash.
Press again to restore the audio. Because the PREAMP 1.0 uses a relay to perform the mute function, it
may take a second or so for this control to respond.
14. Volume
The volume control is always active when the PREAMP 1.0 is powered up and the mute is deactivated.
Note that the control is calibrated in negative decibels (-dB), reaching maximum volume at 0.0 dB and
minimum at -99.0 dB. Thus, when you turn the volume up (clockwise), the number on the front display
will decrease. When you turn the volume down (counterclockwise), the number will increase. The
adjustments steps are in 1 dB increments between -99.0 dB and -50.0 dB, and 0.5 dB increments from -
49.5 dB to 0.0 dB.
15. Rear-panel master power switch
Press this to button to silence the PREAMP 1.0
temporarily. The numerical volume readout will flash.
Press again to restore the audio. Because the PREAMP 1.0
uses a relay to perform the mute function, it may take a
second or so for this control to respond.
9