Dantherm 4000 Series Посібник з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Кондиціонер Dantherm 4000 Series. Dantherm 4000 Series 17 сторінок.
Друкувати сторінкуConnections
Connections
This illustration shows the external connections to the controller
illustration
J2
Supply
SD
al
Temp sensors
J7
NTC -30 to 85°C
(-22 to 185°F)
J4
Power sensors
J1
Valve
J5
Relay drive out
0/12V DC 200mA
ut
2V
AC 1
J11
Fan 1
Alarm
J16
Fan 2
J22
Fan 3
10
Accessory
TTL interface
TTL
(galvanic isolated)
Standard shielded ethernet
cable (568A termination)
1=Gnd
2=B
3=Gnd
RS 485
4=A
5-6=12v line pwr
7-8=line pwr gnd
9: Hotspot sens GND
External
NTC -30 to 85°C
(-22 to 185°F)
interfaces
8: Hotspot sens.
7: Dig GND
Active low
6: Dig2 input
max 12V DC/10mA
J15
5: Dig1 input
4: AC1 relay contact
Max. 42 VAC or 60 VDC. /
500mA. Default normally
3: AC1 relay contact
open - jumper changeable
2: Alarm 1 relay contact
Max. 42 VAC or 60 VDC. /
500mA. Default normally
1: Alarm 1 relay contact
open - jumper changeable
Fig. 7
Connections, continued
The air conditioner can operate as a stand alone cooling system. For enhanced usage, it is
possible to connect an external display with keypad.
See below table for options
Connection
Usage
This output will toogle state open/close if
any operation errors occur.
Alarm 1
Default open OR default close can be set
via a jumper on the PCB.
Factory setting is normally open
This output will toogle state open/close
if highest temperature limit setpoint is
exceeded.
AC 1
Default open OR default close can be set
via a jumper on the PCB.
Factory setting is normally open
This input can control and overrule some
operation parameters. See more in the
Digital input 1
parameters list
Active when low (0V)
This input can control and overrule some
operation parameters. See more in the
Digital input 2
parameters list
Active when low (0V)
Temperature sensor for placing inside the
Hotspot sensor
enclosure, in a hotspot zone if required.
Specification
Potential free
Max. 42 VAC or 60 VDC. /
500mA
Galvanic isolated (500V)
Potential free
Max. 42 VAC or 60 VDC. /
500mA
Galvanic isolated (500V)
0/12V DC
Internal pull up
Max. 10mA
0/12V DC
Internal pull up
Max. 10mA
NTC -30 to 85°C
(-22 to 185°F)
11