Cast S226S Посібник користувача - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник користувача для Дров'яна піч Cast S226S. Cast S226S 16 сторінок.

brush. Wait until the stove has cooled down before doing this. This finish can be

renovated with stove paint from authorised supplier, although the paint may not be

an exact match and it may be necessary to repaint the complete stove/

If the stove is purely ornamental, painting will provide a durable, attractive finish. If

the stove is used for heating, a high temperature heat resistant paint must be used,

in either aerosol or brush applied form. Should rust become apparent, clean

thoroughly with a wire brush and apply a suitable anti-rust treatment.

During prolonged periods out of use, the air inlets should be left open and the door

left slightly ajar in order to circulate fresh air and discourage condensation from

forming which could encourage corrosion.

Fire Rope

Check the rope around the door and glass, if rope is becoming detached, replace

with rope approved for this purpose.

Inspect the fireproof door seals where fitted, to ensure there is an effective seal

around the door and re-fix it if loose using stove rope adhesive. If in poor condition it

should be replaced.

Cleaning the stove

Clean the outside of the stove with a soft brush.

Note that if required the flue can be accessed for cleaning from inside the stove.

Stove glass

Clean any glass panels when cool, avoiding abrasive substances which could

scratch the glass and make subsequent cleaning more difficult. Wet logs against a

heated glass, a badly aimed poker or heavy slamming of the doors could crack the

glass panels. The glass will not fracture with heat. Never replace any broken glass

with glass not approved for use with cast iron stoves.

The window glass should remain clean during normal use but it can become

blackened if the stove is being operated with either damp fuels or at a slow burn rate.

The blackening may be dispersed by burning firefly at a much higher temperature, or

it may be cleaned off using specialist glass cleaner.

In the event of the glass being broken,it can be removed by unscrewing the retaining

clips, taking care not to damage the fireproof seal. The replacement glass should be

carefully placed against the seal and the retaining clips re-tensioned. Take care to

tension these evenly or there is a risk of breaking the new glass pane.