Consult IX CellWizard WTX-35-B Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Передавач Consult IX CellWizard WTX-35-B. Consult IX CellWizard WTX-35-B 15 сторінок. Multi-port cw transmitter
Memory Status
This menu shows the number of utilized and free
memory locations.
(WTX-35-B4 can store up to 24 test channels)
Starting a test scenario
Start a new test
As per the CW Measurement scenario, after identifying Antenna locations, connect the WTX-
35-B4 CW
Transmitter to the Antenna at the first Antenna location now you are ready for starting a CW
Walk Test. Please stick to the following steps to do a proper RF Transmission,
1-
Press "RF ON/OFF" Key. This will recall the last configuration test.
2-
Edit any parameter Freq. or Amp. –if needed- and press "RF ON/OFF" again to start
transmitting (Alternatively, From Main Menu, go to "Start Test", and click Enter)
3-
Adjust the new test channel configuration parameters through the following steps:
-
Write test channel frequency (in MHz) in the relevant band (a standard frequency
step of 100 KHz)
-
Write channel amplitude (in dBm) related to
the selected frequency band
-
You have 4 channels configurations, 1
configuration is for the transmitter port 1, 2
configuration is for the 2
4- Press Key "1" to enable or disable the transmitter
port 1, press Key"2" for enabling port 2 and so on,
then press the RF ON/OFF key. You will notice the
RF indicator appears on the screen
5- After finishing the CW transmission, press "RF ON/OFF" key to stop the RF
transmission.
st
nd
nd
transmitter port and so on