Contacta HLD7 Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Слуховий апарат Contacta HLD7. Contacta HLD7 20 сторінок. Hearing loop driver
Також для Contacta HLD7: Посібник користувача (16 сторінок)
Друкувати сторінку
Changing the driver type
You must be in engineers mode to change the driver type.
Ensure you have selected PAGE 1.
•
When only this first light is illuminated and the driver is in the
engineers mode, press either the LINE + or – to change the driver
type from PERIMETER, PRIMARY OR SECONDARY.
•
When finished setting up the driver type, press the DRIVE – button
to take the driver out of the engineers mode and put if back into
the adjustment mode. The status light will begin to flash.
•
Pressing the MIC (+ and -) buttons simultaneously will take the
driver back to the normal operation mode where the controls are
non-functional.
The three operating modes are:
PERIMETER mode, for a single loop or (with a secondary driver)
•
two widely separated loops.
PRIMARY mode, the first and controlling driver of two in a phased
•
array loop layout.
SECONDARY mode, the second driver of two in a phased array
•
loop layout.
MIC
contacta HLD9
CLIP
ACTIVE
MIC
LINE
PHTM
CLIP
CLIP
PERIMETER
ACTIVE
ACTIVE
PRIMARY
PHTM
LOW SIG
SECONDARY
MIC
CLIP
ACTIVE
MIC
LINE
PHTM
CLIP
ACTIVE
PHTM
2.5
contacta HLD9
LINE
2.5
5
7.5
10
CLIP
PERIMETER
ACTIVE
PRIMARY
DRIVE
LOW SIG
SECONDARY
STATUS
POWER
contacta HLD9
LINE
2.5
5
contacta HLD9
CLIP
PERIMETER
ACTIVE
PRIMARY
LOW SIG
SECONDARY
CLIP
PERIMETER
ACTIVE
PRIMARY
LOW SIG
SECONDARY
MIC
CLIP
ACTIVE
PHTM
5
7.5
10
DRIVE
STATUS
POWER
2.5
5
7.5
10
7.5
10
DRIVE
STATUS
DRIVE
POWER
con
STATUS
POWER
LINE
CLIP
P
ACTIVE
P
LOW SIG
S
9