Contacta HLD9 Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Слуховий апарат Contacta HLD9. Contacta HLD9 20 сторінок. Hearing loop driver
Друкувати сторінкуTechnical Specification
Mains input
Voltage: 100V-120V /200V-240V AC (Universal auto switching)
Frequency: 50Hz-60Hz
Power: 200W
Connection: IEC
Audio Inputs
Input 1
(Microphone) Balanced XLR with switchable phantom power or ¼" TRS jack for electret
microphone with 12VDC power via 680Ω load
Adjustment range: Off, then to maximum in 50x 1dB increments
Input 2
(Line) Balanced XLR or ¼" TRS jack (TRS gives galvanic isolation) input
Adjustment range: Off, then to maximum in 50x 1dB increments
Loop output
Loop connection 4-pole speakON connector
Adjustment range
Off, then too maximum in 63 1dB increments
Loop drive current
10A RMS compliance current @ 1Khz sine wave (loop dependant)
Loop drive voltage
36V RMS compliance voltage (loop dependant)
Loop current frequency response
100 Hz – 5kHz (±3dB) (loop dependant)
Distortion
Better than -51dB, inputs at nominal level
Expansion
Contacta interconnect Input or output to or from additional Contacta products with 90º phase
shift selectable
Status
Volt-free relay contacts SPCO
Feature
External monitor & control Contacta communications processor interface
Displays
Microphone level 8 level bar graph with peak hold, 6dB steps
Line level 8 level bar graph with peak hold, 6dB steps
Output drive level 8 level bar graph with peak hold, 0.6A steps
Other indications LEDs for all setup and status indications
Dimensions
Height – 2.48" (2U 19" rack mount)
Width – 7.87" (19" half rack)
Depth – 10.47"
Weight 3.8lbs
Construction/Finish
Front & Rear: Mild Steel / Top & Bottom: Aluminium Powder Coated Black
Continual improvement policy
Contacta has a policy of continual improvement for its products. This means that designs and
specifications are subject to change without notice.
16