3xLogic VIGIL NVR-2U-64CH Посібник із швидкого старту - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання 3xLogic VIGIL NVR-2U-64CH. 3xLogic VIGIL NVR-2U-64CH 9 сторінок. 64-channel network video recorder

Друкувати сторінку

QUICK START GUIDE | NVR-2U-64CH

1.2 POWER SOURCE

A stable power source is essential for reliable and uninterrupted operation of the Point of Service Personal Com-

puter (PC). The power supply is designed to support 100-240VAC @ 50-60Hz. Use an electrical outlet that is ded-

icated to the PS and has the correct rating.

1.3 PROPER STARTUP / SHUTDOWN

The computer must be started and shutdown properly. To start and shutdown the server, a proper procedure

must be followed, just like in any other PC-based system.

STARTUP

To startup the server

1. Ensure the power cable is fully installed in the power supply

2. Press the toggle switch on the front of the chassis with the symbol on it.

Switch provided at front of equipment is not 'stand-by':

SHUTDOWN

To shut down the server

1. Close all running applications and save all work

2. Navigate to Start -> Shut Down and follow the on-screen message prompts

Warning: Failure to properly shutdown the desktop can result in data loss.

3. Fully disconnect all power cables before servicing system.

1.4 ENVIRONMENTAL REQUIREMENTS

The environmental conditions for a server are essential for reliable and uninterrupted operation. The servers are

PC-based systems equipped with the proprietary hardware that make it a powerful system. Just like a consumer

PC, it must be operated under proper environmental conditions.

MOUNTING

1. Appropriate mounting / slide rails should be used to mount the server into a standard-width rack.

Warning: Rack mounted devices are not to be used as shelves or workspaces. Do not

place objects on top of rack-mounted devices.

Stability Hazard:

■

The rack may tip over causing serious personal injury

■

Before extending the rack installation position, read the installation instructions

■

Do not put any load on the slide rail mounted equipment mounted in the installation position

■

Do not leave the slide-rail mounted equipment in the installation position

■

Equipment is not intended to be serviced while extended on slide-rails.

2. In addition, the lack of free air flow around the units can cause overheating.