Contacta IL-K300 Посібник з встановлення та експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник з встановлення та експлуатації для Конференц-система Contacta IL-K300. Contacta IL-K300 12 сторінок. Above the counter loop system
Друкувати сторінкуSymptom
No power detected
through amplifier
POWER LED
illuminated red
INPUT LED
illuminated red
OUTPUT LED
illuminated red
Red LED illuminated
on microphone
(if halo indicator
microphone is
installed)
No audio is heard
through the hearing
loop via a hearing aid
or loop listener
Interference
(buzzing/whistling/
hissing) is heard
through hearing loop
Unit does not go into
power saving mode
If you are still experiencing problems, please contact your local dealer.
Troubleshooting
Possible Fault
1) Power jack not plugged in or
faulty
2) Plug fuse has blown
3) Faulty power supply unit
4) Faulty amplifier
1) Faulty or incorrect power
supply connected
1) Faulty or incorrectly
connected microphone
1) Faulty or incorrectly
connected loop aerial
1) Constant red LED:
Microphone fault
2) Red LED comes on after
speech:
Hearing loop aerial fault
1) Hearing loop disconnected
2) Microphone disconnected
1) Unscreened or poorly
earthed third party equipment
is being used in close proximity
2) Incorrect power supply
being used
1) Ambient noise in area is too
high
Action
1) Check power jack is firmly
plugged in
2) Put the unit to one side and seek
further advice
3) Change the power supply unit
4) Contact your local dealer
1) Ensure the correct power supply is
connected (PS-55-00)
2) Contact your local dealer if not
1) Check microphone is wired
correctly in green plug and
connected to "MICROPHONE"
socket on back of HLD2 driver
1) Check loop aerial is connected
to "LOOP" socket on back of HLD2
driver
1) Ensure microphone is firmly
plugged in
2) Check to make sure the hearing
loop connector is firmly plugged in
1) Check above for correct
connections
2) Ensure loop listener has a new
set of batteries
1) Switch off any third party
equipment to identify the source of
interference
2) Ensure that our grounded power
supply unit is being used (PS-55-00)
1) Switch off any air con systems,
desktop fans and or computers to
reduce ambient noise
11