DAPAudio CA-3150 Посібник - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник для Підсилювач DAPAudio CA-3150. DAPAudio CA-3150 12 сторінок.
Друкувати сторінку
CA-3150
Power Switch ON/OFF
Flick the switch to turn the device on/off.
Power LED
The LED will light in green when the CA is switched on.
PROT, CLIP, SIGNAL LEDs
PROT: The LED will light in red when the amplifier is in protection mode. Switch off the device and
find out what the problem is. The amplifier is protected against overheating, overload, short
circuit, etc. Decrease the source signal level and/or improve air circulation in the room where
the CA is installed.
CLIP: When the LED lights in red, it indicates distortion. In this case, decrease your source signal
level until the LED turns off. Please keep in mind that the amplifier itself cannot correct any
distortion.
SIGNAL: When the LED lights in green, it means that the CA is operating within its safety limits.
Gain controls (CH A/B)
Turn the controls to set the corresponding channel's gain level.
Gain control SUB
Turn the control to set the corresponding channel's gain level.
Air intake grill
Backside
Euroblock balanced IN
Euroblock balanced inputs for CH A/B/SUB.
Cutoff frequency selectors
Cutoff frequency selectors for hi-pass (CH A/B) and low-pass (SUB) filters. The adjustment range is
between 50-250Hz.
Mode button
If the input signal is filtered and all the 3 channels are available, depress the button to set it to
SUB position.
If the input signal (stereo) needs additional amplification of its low frequencies, press the button
to set it to CHA+CHB position. The device will filter and amplify A+B signal and will feed the
subwoofer only with the low frequencies.
Euroblock CH A speaker OUT
Connect the device to speakers. The upper and lower outputs have the same function.
Euroblock CH B speaker OUT
Connect the device to speakers. The upper and lower outputs have the same function.
Euroblock SUB speaker OUT
Connect the device to speakers. The upper and lower outputs have the same function.
Air exhaust
Do not block the air exhaust as it may cause overheating and/or other serious damage.
210-240V AC, IEC power connector IN + Fuse T4AL/250V
Ordercode: D4511
6
Fig. 02