DAPAudio D4190 Посібник - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник для Підсилювач DAPAudio D4190. DAPAudio D4190 18 сторінок.
Також для DAPAudio D4190: Посібник (18 сторінок)

Друкувати сторінку

Bridged Mono Mode

Bridged Mono Mode straps both amplifier channels together to make a very powerful, single-channel

monaural amplifier. One channel "pushes" and the other "pulls" equally, doubling the power over that of

channel alone. Signal is applied to the Channel A input only. Both attenuators are used to control signal

level; in addition, both must be adjusted to the same setting. Only channel A input may be

Use extreme caution when operating the amplifier In Bridged Mono Mode. Never ground either side of

the speaker cable when the amplifier Is in Bridged Mono Mode; both sides are "hot. "If an output patch

panel is used, all connections must be Isolated from each other and from the

Important!!!

Absolute minimum nominal load Impedance for bridge operation Is:

TAS1100 and TAS4000:

TAS1500, TAS1900 and TAS2400:

Connecting amplifier outputs to oscilloscopes or other test equipment while the

amplifier is in bridged mode may damage both the amplifier and test equipment!

8 Ohm.

4 Ohm.

used.

panel.

Fig. 6