DAPAudio DM-2000 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач DAPAudio DM-2000. DAPAudio DM-2000 16 сторінок.

DM-1000 / DM-2000

Frontside

Power Switch ON/OFF

Flick the switch to turn the DM on/off.

Gain control (CH1)

Turn the control to set the channel's gain level.

POWER, PARALLEL/BRIDGE, PROTECT, SIG/CLIP LEDs

POWER: The LED will light up when the DM is switched on.

•

PARALLEL/BRIDGE: The LEDs will light up, depending on which mode is currently active: parallel

•

or bridge.

PROT: The LED will light in red when the amplifier is in protection mode. Switch off the device and

•

find out what the problem is. The amplifier is protected against overheating, overload, short

circuit, etc. Decrease the source signal level and/or improve air circulation in the room where

the DM is installed.

SIG/CLIP: When the LED lights in green, it means that the DM is operating within its safety limits.

•

When the LED lights in red, it indicates distortion. In this case, decrease your source signal level

until the LED turns off. Please keep in mind that the amplifier itself cannot correct any distortion.

Gain control (CH2)

Turn the control to set the channel's gain level.

Air intake grill

Ordercode: D4212 / D4213

Fig. 01