Duratuf Sentry Shed SL1507 Інструкція з монтажу Посібник з монтажу - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Зберігання на відкритому повітрі Duratuf Sentry Shed SL1507. Duratuf Sentry Shed SL1507 15 сторінок.

Друкувати сторінку

ASSEMBLE BACK PANEL

SELECT:

3 x 1.810m Wall Sheets

1 x 1.520 m Top Plate (Red)

1 x 1.520 m Bottom Plate (Green)

36 x 30mm Galv Clouts

4 x Rivets

STEP 1:

• Lay out 1 x Top Plate and 1 x Bottom Plate on a

flat surface as shown (corner cut outs to face in-

wards).

STEP 2:

• Place 3 x 1.810 m wall sheets on top of timber

Plates with bottom of sheets flush with each oth-

er.

• Rivet the sheets together on overlaps as shown

STEP 3:

• Nail the wall sheets to the Top Plate at each end making sure

that the top of the sheets are flush with the top of the Top

Plate and that the sides of the wall sheets overhang the Top

Plate by 15mm as shown.

• Check that the Top Plate is straight then nail wall sheets to

the Top Plate, using two clouts per pan.

Std Shed — Bottom Plate will protrude below wall sheet by

approximately 10mm.

Raised base plate shed — Wall sheet will protrude below

the Bottom Plate by 20mm

STEP 4:

• Nail the wall sheets to the Bottom Plate at each end,

ensuring that each side of the wall sheets overhangs the

Bottom Plate by 15mm and that the distance between

the Top and Bottom Plates is correct. (As shown)

• Check that the Bottom Plate is straight then nail

wall sheets to the Bottom Plate, using two clouts per

IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER

BASE PLATE –READ THE FOLLOWING;

For sheds with Raised Base Plate option only (see page 6), deduct

30mm from measurement shown between Top and Bottom Plates on

all wall panels, so cladding protrudes 20mm below bottom plate

1776mm

15mm

1776mm

15mm

pan.

TOP PLATE

1776mm

BOTTOM PLATE

TOP PLATE

BOTTOM PLATE

15mm

TOP PLATE

BOTTOM PLATE

15mm

1776mm